Add Floor Trusses
Framer
You can use this function to define a truss area and to add trusses to a floor. The top and bottom surface of the truss area are determined by the top and bottom surface of the floor's FRAMING type layer.
- Select Modeling | Panel | Truss Special Trusses Floor Trusses.
- Select the truss parameters. The previously selected parameters are the default parameters. You can reselect the parameters by using the function Edit truss parameters in the auxiliary menu.
- Select the area.
- Select Confirm. The cursor will turn into a vertical line.
- Before you click the start point of the truss spacing, you can change the direction of the
line as follows:
- Press the Arrow Right or Arrow Left key.
- Right-click to open the context-sensitive menu and select one of the following:
- Vertical
- Horizontal
- Default (direction of the riser on a sloping plane)
- Select direction
- Select the start point of the direction line.
- Select the end point of the direction line.
- Do either of the following:
- Select the point from which the truss spacing will be started. The trusses will be divided in both directions starting from the selected point.
- Select Confirm. The positioning of the trusses will be started from the left edge of the area (trusses in the y axis direction) or from the top edge (trusses in the x axis direction).
- Select the support structures. You can edit the selection by clicking a selected structure to remove the selection.
- Select Confirm.