The Part Drawings Dialog Box

Framer

Select the parts of which you want to create drawings in the dialog box.

PIECE DRAWINGS

Select the check box, when you wish to create part drawings of profiles. In addition, select the following:

  • Drawing template - Select the template to be used. The templates provided by the software supplier are located in the ../system/picts folder. The customer-specific templates are located in the ../custom/picts folder.
  • Filter perpendicular cut pieces - Select this checkbox when you do not wish to form part drawings from simple, straight parts with no saw cuts or notches. In addition, you can select the following:
    • Allow one cut in main direction - Part drawings will not be formed of parts with a maximum of one saw cut in the main direction.
    • Allow one notch in main direction - Part drawings will not be formed of parts with a maximum of one notch in the main direction.

Update Subelement Drawings - Select the check box, when you also wish to update the panel drawings of the sub panels included in the panel. A sub panel can be a beam panel consisting of several profiles, for example. The function does not generate the part drawings of sub panels.

SHEET DRAWINGS

Select the check box, when you wish to create part drawings of sheets. In addition, select the following:

  • Drawing template - Select the template to be used. The templates provided by the software supplier are located in the ../system/picts folder. The customer-specific templates are located in the ../custom/picts folder.
  • Ignore full sheets - Select the checkbox, when you do not wish to create part drawings of full-size sheets. A full-size sheet is of the same size as a sheet in the sheathing library. It has not been cut on any side.
  • Ignore rectangular sheets - Select the check box, when you do not wish to create part drawings of rectangular sheets regardless of their size.