Add an Eave Line

You can use this function to add an eave line in the 2D drawing of a building. After adding the eave line, you can add a roof by clicking the points of the eave line.

Do not use eave lines when adding a roof to a parametric building model.

Add an eave line by clicking the lines of the wall according to which the eave line runs. The eave line is a line chain that can be managed with the line functions.

The eave line is normally added without selecting the roof parameters, in which case the parameters are selected later when the roof is being added. In special cases, parameters can be selected already when adding an eave line by selecting trusses or rafters as the roof structure. The roof overhang has a default value, which has been defined with the building parameter ROOF_OVERHANG.

1. Do either of the following:
   • Select Modeling | Floor, Roof | Roof Eave Line.
   • Right-click to open the context-sensitive menu, and select Eave Line.
2. Select undefined eave structure (default), roof trusses, roof rafters or attic from the auxiliary menu.
   • None (Undefined structure). Define the parameters later when adding a roof.
   • Trusses
   • Rafters
   • Attic
3. Select the roof overhang from the quick selections, or use the function Roof overhang.
   • Roof Overhang Quick Selections
   • Roof Overhang
4. Click the first line of the wall. When you add the eave line (A) in a drawing-model pair where the walls are displayed as a reference drawing, click the wall line (B) from the side on which the roof overhang is to be added.

   

5. If necessary, select a new roof overhang.
6. Click the other lines/walls such that the eave line forms a continuous line chain.
7. After clicking the lines of all walls, select the Confirm function.