Auxiliary Functions when Adding a Pipe or Duct Line

You can select functions when adding a pipe or duct line.

Line sweep direction

• Lock to Handle Direction (2D, 3D)
• Planar Face Normal (3D)
• Line Direction (2D, 3D)
• Release Constraints (2D, 3D)

Line sweep plane

• Planar Face (3D)
• Line Plane (2D, 3D)
• Based on Three Points (3D)

Continuing a Line

• Building in Z Direction (2D, 3D)
• Automatic Routing (2D, 3D)
• Move Parts in Z Direction if Needed (2D, 3D)
• Move Parts in XY Plane if Needed (2D, 3D)
• Pipe Seam: Jointed Pipe (2D, 3D)
• Pipe Seam: Continuous Pipe (2D, 3D)
• Pipe Tee-set-on (2D, 3D)