Start and End of an Angle Weld

You can click the start and end points for an angle weld when the Click start/end checkbox is selected in the dialog box.

In our example, there is no value in the Offset field (it is empty). Click the start and end points as follows:

1. Select a face on a part to determine the base plane of the weld.

   

2. Click a point on a sweep line on another part to be the start point of the weld.

   

3. Reselect the base plane from the part (the same face as previously).

   

4. Click a point on a sweep line on another part to be the end point of the weld.
   
   

The weld direction is determined by the right-hand rule. The thumb points in the direction of the base plane normal, and the direction of the fingers in the fist determine the direction of the weld.