Flatten Spline Surface

Draw the closed spline by selecting the control points.

  1. On the tab, in the Lines group, click Spline.
  2. Select the line points in the 3D sketch.
  3. If you select as the line first point some line end point, the tangential spline is drawn automatically.
  4. Select Confirm.
Note:
  • Set the tangential on or off by clicking the minimenu tangent button.

     

Flatten Spline Surface

  • The spline surfaces are flattened in accordance with neutral axis. The bends done with the older versions are created in accordance with the selected surface.