Fitting the Truss

When you are clicking the truss line points, you can enable the fitting of the first and/or last truss. When you use the truss fitting, the edge of the truss will be set on the point of the truss line. When you are not using the fitting, the center of the truss will be set on the point of the truss line. The other trusses will be spread in the area according to the spacing determined in the parameters and the location method selected.

Select a function from the auxiliary menu:

• Fit First Truss
• Fit Last Truss

If you have defined an offset (d) for the start and/or end of the truss area in the truss parameters, the edge or center point of the truss will be positioned at offset distance from the truss line point.

= clicked point of truss line