Move a Truss Label by the Grip Point

Framer

The location of the truss labels is defined in the truss parameters. You van move a single truss label from the grip point.

  1. Select the truss.

    The program adds three grip points to the truss: one at the center of the truss and two at the ends of the truss. You can move or stretch the truss by selecting one of these grip points.

  2. Move the cursor on the truss label. The truss label grip point appears. You can move the truss label by selecting this grip point.

  3. Click the truss label grip point.
  4. Select the new location of the label. The cursor is automatically locked to move along the truss.

Note:
  • You can also move the label by selecting Drafting | Text > Edit Text. You can then also change the text's locating point or position angle.