Add Extensions
Framer
Add an extension to a truss end at the roof eave, in the direction of the top chord.
- Select Modeling | Accessory Component | Profile Eave Extension.
- Select the truss. Click the truss on the end and on the side on which you wish to add the extension.
- Select the cross section by using the Properties function. The cross section you selected will be set as the default until you select another cross section.
- Determine the extension length by doing one of the following:
- Select the extension overhang and length or overlap using the Parameters function, and confirm the position of the extension's end point by selecting the Confirm function.
- Select the extension overlap using the Parameters function, and select the position of the extension's end point by clicking.