Recalculating Values in Panel Stacking

Framer

You can edit the values of the panel stack variables. The values are displayed in the diagram as text macros. They are dimensions determined by selecting the end points in the drawing. They are always determined in the same order. The program will recalculate the dimensions according to the points selected, and refresh the text macros in the drawing.

  1. Select Classic Wall Framing | Panel Stacking Recalculate Panel Stacking.
  2. Define the fork hole width.
    • Select the first point.
    • Select the second point.
  3. Define the height of the stack.
    • Select the first point.
    • Select the second point.
  4. Define the length of the panel on top of the stack.
    • Select the first point.
    • Select the second point.
  5. Define the length of the base panel.
    • Select the first point.
    • Select the second point.
  6. Define the maximum length of the stack.
    • Select the first point.
    • Select the second point.

Note

  • You can edit the value of the maximum stack height by using the Panel Stack Height function.