Add a Hole by Lines

You can add a hole to a horizontal structure. The hole can go through the entire structure or it can be added only to the selected structural layer. The same hole can cut several horizontal structures located side by side.

1. Select a structure and a layer, if necessary.

   Select a Structure and a Layer

2. Select Plane Structure | Volume | Hole Hole Using Lines.
3. In the case of a sloping structure, select, if the points are to be buildinged to the top or bottom surface of the structure.
   • Measure height to top - The edge points are buildinged to the top surface of the structure.
   • Measure height to bottom - The edge points are buildinged to the bottom surface of the structure.
4. In the case of a sloping structure, select perpendicular or vertical edges to the hole.
   • Perpendicular edge - The edge direction is perpendicular to the structure.
   • Vertical edge - The edges are vertical.
5. Select lines or a line chain. The lines can be single lines or they can form a closed polyline. The edge lines can reach outside the structure and run across several horizontal structures.
6. Select Confirm.