Add a Hole Using Points

You can add a hole to a horizontal structure. The hole can go through the entire structure or it can be added only to the selected structural layer. The same hole can cut several horizontal structures located side by side.

1. Select a structure and a layer, if necessary.

   Select a Structure and a Layer

2. Do either of the following:
   • Select Plane Structure | Volume | Hole.
   • Right-click to open the context-sensitive menu, and select Create Hole.
3. In the case of a sloping structure, select, if the points are to be buildinged to the top or bottom surface of the structure.
   • Measure height to top - The edge points are buildinged to the top surface of the structure.
   • Measure height to bottom - The edge points are buildinged to the bottom surface of the structure.
4. In the case of a sloping structure, select perpendicular or vertical edges to the hole.
   • Perpendicular edge - The edge direction is perpendicular to the structure.
   • Vertical edge - The edges are vertical.
5. Select the corner points of the hole. You can add a rectangular hole by clicking just 2 points: the start and end points of the diagonal. In the model, you can first select wire frame as the method of representation, in which case it is easier to select points of the model. The selected points are buildinged either to the top or bottom surface of the structure. The edge points can be located outside the structure and the line chain, which they form, can run across several horizontal structures.
6. Select Confirm.