Add All Machining Lines to All Wall Panels

Framer

When you are panelizing walls using the method based on the panel drawings, you can add all the machining lines defined in the settings to all wall panels as follows:

  1. Activate the desired drawing-model pair.
  2. Select Classic Wall Framing | NC Accessories Add All NC Accessories to All Wall Panels.

    The function goes through all the wall panel drawings of the active drawing-model pair. Each drawing is opened, machinings defined in the settings are added, then the drawing is closed and saved.

  3. If necessary, activate another drawing-model pair and select the function again.
Note:
  • When you are panelizing walls using the method based on the model, select all panels and the function Panel | Framing | NC Accessories.