2D Panel Stacking
Framer
You can use these functions to create panel stack diagrams and panel stack drawings, edit the data of a stack diagram, and highlight the trusses belonging to the same stack in the floor plan or the building model. A panel can be a floor, ceiling, roof or wall panel or a truss.
- Automatic Panel Stacking
- Create Panel Stacks
- Create Drawings from Panel Stacks
- Edit Panel Stack Data
- Remove Panel Stack Data
- Panel Stack Height
- Highlight Stack Panels
Note:
- You can use either 3D or 2D stacking functions in the building. It is not possible to use both functions in the same building.
- If model-based wall panels are not enabled, 3D panel stacking is also not available.