Edit Trim Piece Connections

With this function, connections of trim pieces connected to an eaves are edited. The trim piece has been connected to the eaves by confining it to a certain default location and direction. This function is used to change the confining of the trim. If the eaves structure is altered at a later stage, the eaves trim is positioned on the changed eaves according to the selected connection information.

1. Select Modeling | Connection | Joint > Trims Edit.
2. Select the trim piece.
3. Select how to confine the trim piece to the eaves. Select one of the following from the auxiliary menu.
   • Snap to upper edge
   • Snap to bottom edge
   • Snap to edge
4. Select a new direction from the auxiliary menu:
   • Direction from upper edge
   • Direction from end of roof slope
   • Direction from angle of bottom edge
   • Direction locked to profile plane
5. Select Confirm.

In the example figure, the gutter is selected, and the options Snap to upper edge and Direction locked to profile plane are selected from the auxiliary menu. The direction of the gutter remains unchanged even if the slope pitch or the shape of the eaves is changed.