Add All Machining Lines to a Panel

Add all the machining lines defined in the settings to the selected panels as follows:

1. Select one or more elements. You can select all panels of the same type by pressing Ctrl+A.
2. Select Panel | Framing | NC Accessories.

   If there is only one setup file that defines machining lines, CncAccessories.setup, the machining lines defined in it will be added to the selected panels.

   If there are multiple setup files, a list will open from which you can select the file to use. You can save the selection to the panels by selecting Save selection to the panel. Next time, you do not need to select the setup file.

   It is possible to save the setup file in the properties of the panels even before adding the machining lines. Read more in section Customer-specific machining.

   If the selected panels include both panels for which a selection was previously saved and panels for which a preselection is missing, the selection made when adding the machining lines will only apply to those panels that did not have a preselected setup file.

3. If there are multiple setup files, you will be prompted: "Update machining lines?" Select either of the following:
   • Yes - The program adds the machining lines defined in the settings and deletes the single machining lines added earlier.
   • No - The machining lines of the panels will remain unchanged.