Customer-specific machining

Framer

Customer-specific machinings are defined in a setup file in the ../custom/setup folder. There can be several setup files. The default file is called CncAccessories.Setup. Other files should be named as follows:

CncAccessories(DESCR).Setup.

DESCR is a name describing the machining line. For example:
  • CncAccessories(Randek33).Setup
  • CncAccessories(Randek55).Setup

When adding a machining line, the program asks you to select the file to be used. The option Default is the CncAccessories.Setup file. It is possible to save the selection to an panel, after which the program will not ask for the file to use. You can save the selection in the panel properties before adding machining lines or during the addition.

Save the selection before adding machining lines by editing the panel properties:
  1. Select one or more panels.
  2. Right-click and select Panel Properties. The Panel Properties dialog box opens.
  3. Select the file to use from the CncAccessories setup list.
    Note: You can later remove the selection from the panel by selecting No selection from the list.
  4. Confirm by clicking OK.

If the selection has not been saved in the panel properties, the program will ask you to select the file to use when you add machining lines to the panel. In this case, select Save selection to the panel, after which the program will not ask for the file again.