Renumber Panels

Framer

You can renumber panels as follows:

  1. Select Output | Panels and Trusses | Change Label . You can use the function to edit panel labels in two ways:
    • Renumber Panels - This is the default method. The status bar displays the following prompt: "Renumbering Panels (number): Select a panel (1)."
    • Change the label prefix - The status bar displays the following prompt: "Renumbering Panels (prefix): Select a panel."
  2. Check the renumbering mode in the status bar prompt.

    If necessary, switch the renumbering mode using the Switch renumbering mode function in the auxiliary menu until the prompt reads as follows: "Renumbering Panels (number): Select a panel (1)."

  3. Select the first panel.
  4. Press and hold the Ctrl key to select the other panels. Select the panels in numerical order from smallest to largest.
  5. Select Confirm. The Panel Numbering dialog box opens.
  6. In the dialog box, type the number you want to start the panel numbering from.
  7. Confirm by clicking OK.

    When renumbering the selected panels, the program will assign the starting number to the panel selected first, after which the starting number is increased by one. The panel prefixes will remain unchanged.

Note

  • If any of the numbers is already in use, the program will display an error message and the renumbering will not be performed.