Web Stiffener

Framer

Add the joint in the model window.

a = Stiffener

  1. Select Modeling | Panel | Floor > Framing Accessories. The browser is opened.
  2. Select the Roof Accessories folder in the browser.
  3. Select Web stiffener.
  4. Select the parameters in the dialog box:
    • Stiffener amount on one side (PCS) - The same number of stiffeners are placed on both sides of the web.
    • Stiffener thickness (T)
    • Stiffener width (W)
  5. Confirm by clicking OK.
  6. Define the position and alignment by clicking two points.
  7. Select the profiles. Select the profiles one by one or use area selection.
  8. Select Confirm.
Note: