Generating a Section View of Panel

Framer

You can add a section view of a panel to the panel drawing. You can generate either a vertical or horizontal section of any part of the panel, and add it to the panel drawing. Before using the function, you need to open the panel drawing using the Opening a Panel Drawing function.

When the function is selected for the first time, the cursor will turn into a horizontal line from the left edge to the right edge of the drawing window. You can make the section vertical by using the DIR function.

  1. Select Classic Wall Framing | Panel | Cross Section. The cursor will turn into a horizontal line from the left edge to the right edge of the drawing window.
  2. If necessary, select the DIR function, which will change the cross section direction to vertical.

  3. Click the section point.
  4. Select the location of the section view in the panel drawing. When adding a horizontal section, the cursor will be locked in the vertical direction, so you can select the location of the section above or below the front projection of the panel. Correspondingly, the cursor will be locked in the horizontal direction when adding a vertical section.