Trimming a Profile

Framer

You can trim a piece to any line in a panel drawing. When you select the edge line of another piece as the reference line, the program will mark the entire piece as selected, but the piece will be trimmed to the line selected.

  1. Select Classic Wall Framing | Panel | Edit Profile Trim Profile.
  2. Select the reference line.
  3. If necessary, you can determine the distance between the end of the piece to be trimmed and the reference line by using the OFFSET function. Type the offset value in a text box.
    • Positive offset - The end of the piece goes over the reference line for the length of the offset.
    • Negative offset - The end of the piece is left short of the reference line for the length of the offset.
  4. Select the piece to be trimmed. You can select several pieces to be trimmed to the same reference line one after another.
  5. Select Confirm.