Ladder
Framer
Ladders are always added between two studs. Locate the ladder macro at the location of a cabinet, for example. When you generate pieces to a panel, the program adds the extra ladders at even intervals in vertical direction between the nearest studs. Select the parameters of the extra ladders in a dialog box.
Dialog Box Options
- Width
- You can select a cross section from the profile library by clicking the Select button.
- Length
- Type the length (L) of the macro in the field. When you generate the pieces to the panel, the extra ladders are added at the location of the macro between the nearest studs. If necessary, ladders are added to more than one stud space.
- Height
- Type the locating heights of the ladders in relation to the floor base height (ZMASTER) in the field. Type the heights measured to the center lines of the profiles. Separate the heights with commas, for example: 600,1200,1800.
- Side
- Select either of the following as the location of the extra ladders: