Center Line (2D)

Add the centerline in the drawing by clicking a circle, ellipse, it's arc, or click the centerline points in the drawing.

The default center line exceeding is 0.4xRadius. You can remove the centerline’s associativity to the circle by disabling the Centerline constraint in the settings. You can change the settings in the Line Properties dialog box.

1. On the tab, in the Lines group, select
   • Smart > Center Line - Vertex G4, G4Plant
   • Line > Center Line - Vertex BD, InD
   • Closed > Center Line - Vertex ED, HD
2. Select the line properties. Line Properties
3. Edit the offset of the center line, if necessary Select either of the following:
   • Properties (arc's center lines)
   • Properties (other center lines)

   Define the data in the dialog box.

   Defining the Offset of a Center Line
   Defining the Offset of a Center Line of an Arc

4. Add a center line in one of the following ways:
   • Select a circle, ellipse or an arc, to which you add centerlines.
   • Click center line points. Point the direction with two points by selecting Direction points. First, define the direction by clicking two points, and then click the points of the center line.

     

5. Select OK.