Dimension Flattening (angle)

You can dimension the face (2D) of a sheet metal part, beginning from the center point of the arc, using the specified angle.

You can define the angle or number of dimensions. The dimension will not act as a geometric constraint.

 

1. Select Drafting | Dimensions | Fast Dimensioning > Set Dimensions for Flattened Sheet.
2. Select the dimension properties. Dimension Properties (2D)
3. Select the polylines between which the dimensions will be added.
   • Select the lines on the first (1st) side, and select Confirm.

     

   • Select the lines on the second (2nd) side and confirm the selection.
4. Define the dimensioning.
   • Angle a30, for example.
   • Number 10, for example.
5. Select OK.