Reference line quick selections

When a wall is added, the reference line of the wall is set to run through the selected points. With this function, the outer surface of the exterior siding, wall frame center line or inner surface of the interior finish can be selected as the reference line of a wall.

  • Placement: Wall outside
  • Placement: Wall middle
  • Placement: Wall inside
Note:
  • If a special REFERENCE line has been defined for the wall, you can select it as a reference line by using the function Placement: Wall reference line.
  • With the function Select reference line, any point of the wall structure cross section can be selected as the reference line.