Beam Pocket

Framer

Use a beam pocket to define an opening for a beam in a wall panel. Add a beam pocket as follows:

Select Modeling | Panel | Wall Wall Panel Layout Accessories.
Select Beam pockets to floor plan from the browser.
Select a wall. The Beam Pocket Properties dialog box opens.
Select the beam pocket properties.
Beam Pocket Properties
Confirm by clicking OK.
Select a wall.
If necessary, change the locating point of the macro, or select another auxiliary function. By default, the locating point is the center point of the stud or stud group.
Auxiliary Functions for Locating a Panel Macro
Select a location for the macro.
Quit by pressing the Esc key.

Note:

You can relocate the panel macro by dragging the grip point before generating the panel breaks.
If you do not wish to use a beam pocket, the studs located at beams can also be notched by determining a joint between the wall and the beam using the Joint Between Beam And Wall Frame function.