Panel Stacking Criteria

Framer

The stacking criteria of the wall panel stacking diagrams are defined in the WALLS keyword group using the following keywords:

  • StackingMethod - stacking method
  • SetForkHole - hole for the forklift truck (0 = no hole needed, 1 = add hole)
  • MinWidthOfForkHole - minimum width of the hole for the forklift truck
  • MinimumBasePanel - minimum size of the base panels, i.e. the panels at the bottom of the stack
  • MaximumBasePanel - maximum size of the base panels
  • MaximumRowLength - maximum length of the panel on top of the stack
  • MaximumStackHeight - maximum height of the stack
  • MaximumPanelHeight - maximum height of panels, limits the width of the stack
  • StackFloorsSeparate - stack panels from various floors in the same stack (0) or separate stacks (1)

If a hole is used for the forklift, it is always added in the second layer of the stack. The size limits of the base panels affect the five layers at the bottom of the stack, except the layer with the hole for the forklift.

The panel stacking diagrams contain building data loaded from the building parameters as text macros, and the following stack values:

  • height of the stack
  • length of the panel on top of the stack
  • length of the base panel
  • number of base panels
  • maximum length of the stack

The drawing properties of texts are defined in the system settings. The texts in the panel stacking diagram have been named as follows:

text= STACK.FORK

text= STACK.NOTE

text= STACK.PANELID

text= STACK.WARNING

Note: