Setting the First Stud of a Panel

Framer

If the wall consists of more than one panel, you can set the stud adjustment panel-specifically.

  1. Select Classic Wall Framing | Wall Panelizing | Special Framing Set Panel 1st Stud.
  2. Click the center line of the panel.
  3. Click the starting point of the studding. The studs will be distributed from the starting point to both directions according to the stud spacing.
Note:
  • The program will display the stud spacing of all panels on the floor plan drawing.

  • You can hide the stud spacing by using the Hide Stud Spacing function.