Stretch Sidings to a Roof Automatically

You can perform following operations with a single function:

  • Stretch wall layers to the above or below roof. It is required that the layer's properties allow stretching.
  • Clip walls reaching above or below the roof with the roof.
Note: You cannot stretch wall layers which you have edited in the model by using this function. You can stretch an edited layer to a roof by moving the edges and edge points.

Stretch the layers and clip the walls as follows:

  1. Select one or more walls.
  2. Select Wall | Connection | Stretch Automatically.
Note:
  • The layers, which have the property Can be stretched to roof (STRETCH_TO_ROOF) are stretched to the roof, see Wall 3D Volume Properties.
  • You can remove the connection between a wall and a roof by disconnecting the wall from the roof.