Use a Line and Points to Define the Sweep Plane

This function can be used to determine the sweep plane based on three points selected from a model. The cursor is constrained to the sweep plane. Profile sweep is performed in the sweep plane when a point has been selected as the position for the cross-section.

1. Start adding a profile.
2. Click the starting point of the profile.
3. Select the sweep plane by clicking the button: Plane of profile sweep (with line and points).
   • Select three points or
   • Select a line and a point.
4. Select the elements that define the sweep plane:
   • Select a line and a point from the model or.
   • Select three points from the model.
5. Click the end point of the profile.