Closed Polyline

With this function, a closed polyline is added. When adding a line, its line properties are defined. When you have finished selecting the line points, select the Confirm function. The line is modeled from the last selected point to the start point of the closed polyline. If only two line points are selected, a rectangle is modeled.

1. Select Drafting | Lines | Closed Polyline
2. Define the properties of a closed polyline.
3. Select line points.

   

   Before selecting the points, the cursor is set parallel to the plane.

   If only two points of a line are selected from the surface, the result is a rectangle.