Add a Blocking Line to a Framing

This function can be used to add a blocking line between joists in the framing over which the joists will continue unbroken. Framing pieces can be added between the joists as shown in the figure below.

Add a blocking line as follows:

1. Select the structure. The structure’s basic layer whose type is FRAMING becomes automatically selected. If necessary, you can select another FRAMING type layer.

   Select a Structure and a Layer

2. Select Plane Structure | Framing | Framing Gallery Lines.
3. Right-click to open the context-sensitive menu.
4. Select Add Blockings.
5. Click the start point of the line.

   

6. Click the end point of the line.

   

7. Select the framing detail.

   Select framing detail

Note

• As a default, all framing line symbols are visible in the floor plan drawing. If necessary, you can hide the blocking line symbols by clicking the button Blocking lines in the auxiliary menu.