Set Slope Shape

Architectural, Framer

You can use this function to define a section which replaces the shape of a large and complex slope.

Example

You can use the function in a situation presented in the figure below. The slopes which have been selected as the upper limiting slopes of the trusses, have been marked in the figure.

  1. Select the function Set slope shape from the auxiliary menu.
  2. Click the slope whose shape is to be replaced.

  3. Select the corner points of the replacing section.

  4. Select Confirm.

  5. Proceed by selecting another auxiliary function from the contextual toolbar, or quit defining the limiting structures with the Confirm function.