Cut Slope Shape

You can use this function to leave part of a slope outside the truss area.

Example

You can use the function in a situation presented in the figure below. The slopes which have been selected as the upper limiting slopes of the trusses, have been marked in the figure.

1. Select the function Cut slope shape from the auxiliary menu.
2. Click the slope to be cut so that part of the slope is left outside the truss area..
   
3. Select the corner points of the area to be cut.
   
4. Select Confirm.
   
5. Proceed by selecting another auxiliary function from the contextual toolbar, or quit defining the limiting structures with the Confirm function.