Eave type 3

H = Fascia height

L = Top board length

W = Soffit width

D = Distance from click

1. Select Modeling | Panel | Floor Framing Accessories. The browser is opened.
2. Select the Roof Accessories / Eaves folder in the browser.
3. Select Eave type 3.
4. Select the parameters in the dialog box:
   • Fascia height (H)
   • Distance from click (D) - The distance of the vertical board from the selected wall line.
   • Top board length (L)
   • Top board code - Select a cross section for the top board (a) from the profile library by clicking the Select button.

     Piece Properties

   • Top board library
   • Soffit width (W)
   • Soffit support code - Select a cross section for the soffit support (b) from the profile library by clicking the Select button.
   • Soffit support library
   • Vert. board code - Select a cross section for the vertical board (c) from the profile library by clicking the Select button.
   • Vert. board library
5. Confirm by clicking OK.
6. Select the start and end points of the wall line.
7. Select the ends of the rafters. Select the ends one by one or use area selection.
8. Select Confirm.

Note

• The program will automatically create a rafter structure of the joint components, allowing you to use floor and roof panel design functions on it. You can, for example, generate a panel drawing of the joint components, or delete both the panel information and the joint components.