Ridge Joint

Framer

Add the joint in the model window.

a = Stiffener

b = Fish plate

c = Height of the fish plate's bottom edge

  1. Select Modeling | Panel | Floor Framing Accessories. The browser is opened.
  2. Select the Roof Accessories folder in the browser.
  3. Select Ridge Joint.
  4. Select the parameters in the dialog box:
    • Stiffener amount on one side (PCS) - The same number of stiffeners are placed on both sides of the web.
    • Stiffener thickness (T)
    • Stiffener width (W)
    • Fish plate code - Select a cross section for the fish plate from the profile library by clicking the Select button.

      Piece Properties

    • Fish plate library
  5. Confirm by clicking OK.
  6. Select the profile ends. Select the ends one by one or use area selection.
  7. Select Confirm.
  8. Define the height of the ridge joint board's bottom edge. Click the point in the model.

Note