Add a Trim as a Profile

You can add a single trim as a profile.

1. Select Modeling | Accessory Component | Profile.
2. Select a library, cross section and other properties.

   Properties

3. If necessary, change the direction of the cross section.
4. Select the locating point at the start of the profile.
5. Select the start point of the profile.
6. If necessary, select the locating point for the end of the profile.
7. Select the end point of the profile.

Note

• This function does not automatically combine the trim pieces with the adding area, for example an eaves. If necessary, you can connect trim boards to an area by using the Connect a Trim Piece to a Wall or Area function.