Parametric Foundation, Block + Footer

Select the foundation wall parameters in the Wall Selection dialog box.

Material
Select the material from a list.
Blocks
Enter the width (W1) and height (H1) of the block in the text fields.
Footing
If necessary, select the check box Footing, and type the width (W2) and height (H2) of the footing in the text fields.
Narrowed Top
If necessary, select the check box Narrowed Top, and type the width (W3) and height (H3) of the top part in the text fields.
Insulation
If necessary, select the check box Insulation, and type the thickness (T) of the insulation layer in the text field.
Sole Plate
Select the check box, when you wish to add a sole plate (A) to the top of the block. You can select the sole plate's cross section from the profile library by clicking the Select button.
Part Properties
Select the number of sole plates from the Number list. In the example, two has been selected as the quantity. Select the locating plate's distance (d) from the foundation wall's exterior face from the Distance from Edge list, or enter the desired value in the field.