Reflecting Stair Geometry on Another Floor

You can add stair geometry to the floor panel of another floor by reflecting the stair's 2D geometry. The stair will remain unchanged in the model.

1. Select Modeling | Tools Reflect Object.

1. Select the stair.
2. Select Confirm.
3. Select the floor on which you want to reflect the geometry. Select several floors with the Ctrl key pressed down. You will be prompted: "Leave this drawing-model pair active?" The question refers to the drawing-model pair to which you are reflecting the geometry.
4. Do either of the following:
   • If you want to work in the drawing-model pair on which you are reflecting the geometry, select Yes.
   • If you want to work in the drawing-model pair from where you selected the elements, select No.

Note

• When reflecting a stair created with the Stair Generator on another floor, the arrow indicating the direction of the stairs points in the opposite direction from the original geometry if the Reflection is mirrored property has been selected for the stair. See Stair Type Parameters.