Add a Shaft to a Panel

You can add a shaft of the desired size to a wall, floor or roof panel. You can choose to punch the entire structure or only one side. The shaft affects the generation of the frame and sheathing. When you add parts to a panel, the program adds the frame parts around the shaft and cuts an opening in the sheet at the shaft. If the shaft is located in the lower corner of a wall panel, no bottom plate or edge details are added around it.

To resize a shaft, open its properties for editing.

1. Activate the model window.
2. Select Modeling | Connection | Joint > Profiles Connection Details. The browser is opened.
3. Select the browser folder Service Holes / Punches.
4. Double-click the component (0500) Shaft.
5. Select the panel.
6. If necessary, change the locating point of the component, flip the component, edit the parameters of the component, or select another auxiliary function from the menu which opens by right-clicking.

   Auxiliary Functions for Locating a Building Component

7. Select a location for the component in the model.
8. Regenerate the panel parts, and the program adds the frame parts around the shaft and cuts an opening in the sheet.
9. Edit the parameters of the component by selecting the component in the model and Properties from the right-click menu.
   • Width - Enter the width of the component.
   • Length - Enter the length of the component.
   • Punch - Select one or both:
     • By default, both the Punch Up/Exterior and Punch Down/Interior options are selected, allowing the component to punch the entire structure. An opening is cut in the sheets on both sides of the frame layer. The opening is 10 mm larger than the component at all edges.

       

     • Punch Up/Exterior

       

     • Punch Down/Interior