Stretch Cable Routes to Certain Length

The defined length of a cable route has to correspond the length in a table drawing. Stretch the length of a cable route as follows:

1. Select tab, Wiring Harness group Stretch Cable Routes to Certain Length.
2. The program prompts you to click the line end closer to cable branch.

The cable branch to be moved is circled and the stretching cable route is pointed in the picture. Click the cable route with a special pointer, that is illustrated in the picture. A cross pointer, that moves along with the cable allows you to create curves and keeps the length correct.

Clicking outside the cable route area confirms the route location. If you select Ready button, not-located part of the cable route locates itself according to last pointed line.

Start locating by selecting the point from where the cable route placement is started. The rest of the cable route is straightened for relocating. This way you can straighten the curves.