Common/Separate Locating Point

When adding a profile, you can determine the position of the profile by selecting a locating point on the cross section. The locating point can be a different point at the start of the profile and at the end. You can select the locating points at both ends from their own menus. This function can be used to open and close the locating point menu for the end of the profile.

Locating point options for the start of the profile

Locating point options for the end of the profile

You can select one of the nine points on a rectangle drawn around the cross section as the locating point by using the selection buttons. The left and right side of the profile are defined by viewing the cross section from the end point towards the start point. You can also select any point on the cross section as the locating point by using the Selecting Locating Point function.