Add Corner Trims to All Corners

1. Select Modeling | Accessory Component | Component gallery Corner Trim.
2. Click the All button above the status bar. If you cannot see the button, stretch the bottom edge of the Vertex window downwards.
3. Add the corner trims on both sides of the corner. Select the following function from the auxiliary menu:
   • Add Trim on Both Sides
4. Select the cross section of the corner trim.
5. Select whether the corner trims are to be added to exterior corners, interior corners or both. Select one of the following from the auxiliary menu.
   • Exterior Corners
   • Interior Corners
6. You can select the length of the corner trims by clicking, define the corner trims to reach the roof, or select the default height defined in the project parameters for them. Select one of the following from the auxiliary menu.
   • Select Height
   • Stretch Corner Trims to Roof
   • Default Height
7. Define the height of the corner trims according to the selected method.
   • Select height: select the start and end point.
   • Stretch corner trims to roof: select the Confirm function. The program automatically stretches the corner trims of all corners to the nearest roof. The start point of the corner trims is automatically the bottom edge of the exterior siding of the wall.
   • Default height: select the Confirm function.

Note

• You can change the corner trims by defining a component change rule. Select components of the type Corner Trim to be changed. Alternatively, you can define the change operation of corner trims by using the component type Profile.
• The object type of the corner trims is Eave and Wall Trims.