Keywords Connected with Machinings
The LOGHOUSE setup file may contain the following keywords connected with the machinings.
- default_mach_codes
- Defines the machining codes used. The keyword can have the following values:
- endo_mach_list
- Defines the change in the machining direction of the log. The log is machined in the direction it is in the log work drawing when endo_mach_list= 1. The default is the opposite direction.
- half_drilling_min_depth
- A half drilling machining is added to the machining list if it cuts the log with this minimum dimension. The minimum dimension is defined in relation to the log riser. The keyword value is a factor (0.1..0.5) with which the log riser is multiplied. For example:
- mach_endinghalf
- Defines the machining code for the top half log (not a machining macro).
- mach_list_filter
- Defines the filtering of the machining list. Example:
- mach_lower_bevel
- Defines the machining code for a basic 45-degree bevel (not a machining macro).
- mach_opening_cut
- Defines the machining code for notching an opening (not a machining macro).
- mach_starting_half
- Defines the machining code for the base half log (not a machining macro).
- mach_upper_bevel
- Defines the machining code for a basic 45-degree bevel (not a machining macro).
- machining_library
- The machining library, in which machining macros added to log work drawings both automatically and separately are defined, is set with this keyword. Refers to a subdirectory in the Comblibs directory.
- min_clip_hgt_for_notch
- A below or above notch is automatically added to a log, if the crossing wall cuts the log with this minimum dimension. Example:
- upd_machinings
- Defines the updating of machinings in the log work drawing. The keyword can have the following values:
Note
- Machinings are included in the Log House Work Drawings add-on feature.
- Machining list is included in the Log NC Interface add-on feature.