Connect Pipe or Duct Lines

Piping Design

When you remove a component between two pipes/ducts, the line is broken. Complement the missing section by adding a pipe or duct line between grip points.

  1. Do either of the following:
    • Select Modeling | Pipe.
    • Select Modeling | Pipe Duct.
  2. Move the cursor near the grip point of the pipe/duct. The cursor snaps to the grip point. Select the grip point.

    The pipe/duct information is determined by the selected grip point.

  3. Select the grip point of a pipe/duct to be connected.

    The parts are connected. A continuous line is created.

Note

  • You can also connect parts by adding a grip point linkage between them. A seam is created between pipe or duct parts.