Project-specific Layer Settings
You can select to use project-specific layer settings instead of the default layer scheme. The settings are saved in a project-specific component library. You can disable the project-specific settings by re-enabling the default layers of the system. In this case, the component library folder is deleted from the project folder.
- Open the project's document browser.
- Open Settings > Design settings.
- Double-click Default layers.
- Do either of the following:
- Use system layers as default - The project-specific layer settings are disabled, and the component library folder complibs/vxlayer-schemes_proj is deleted from the project folder.
- Use project-specific layers as default - Set the desired layers by clicking Edit project-specific layers. Edit the layers in the same way as the layers in the default layer scheme. The settings are saved in the project-specific component library complibs/vxlayer_schemes-proj folder.
- Select Update layers in existing drawings to load the selected default layer scheme (system layers or project-specific layers) into all project’s drawings. The layer names, visibility and layer groups are updated to the project’s drawings.
- Confirm the updating of the project's drawings by clicking Yes.
Note: Selecting Update layers in existing drawings corresponds to the function Restore Default Layer Scheme for the Entire Project, but to switch from project-specific layers back to system default levels, you must perform the update with this Default layers function in the project document browser.