Rotate the Model
Rotate the model. Note that the entire model space rotates. This function does not rotate the model to another position.
- By default, the model is rotated in an axonometric projection.
- You can switch the rotation to a perspective projection by pressing Shift+cursor key.
Do as follows:
- On the tab, in the Projection group, click Isom Rotate.
- Select the direction with the arrow keys.
- Right arrow = model rotates counter-clockwise around vertical axis.
- Left arrow = model rotates clockwise around vertical axis.
- Up arrow = model rotates around horizontal axis "away".
- Down arrow = model rotates around horizontal axis "towards".
- You can set the rotation around both the horizontal and vertical axis at the same time.
- Select the speed of movement with the number keys 1 (minimum) to 7 (maximum).
- You can also change the speed during rotation.
- Stop rotating by pressing the arrow keys.
- Start rotating again by pressing the arrow keys.
- Quit by pressing the Esc key.
If the model disappears from the working window, restore it by selecting a projection from the Projection group.