Edit Trim Piece Connections

With this function, connections of trim pieces connected to an eaves are edited. The trim piece has been connected to the eaves by confining it to a certain default location and direction. This function is used to change the confining of the trim. If the eaves structure is altered at a later stage, the eaves trim is positioned on the changed eaves according to the selected connection information.

1. Select Modeling | Connection | Joint Trims Edit.
2. Select the trim piece.
3. Select how to confine the trim piece to the eaves. Select one of the following from the auxiliary menu.
   • Snap to upper edge
   • Snap to bottom edge
   • Snap to edge
4. Select a new direction from the auxiliary menu:
   • Direction from upper edge
   • Direction from end of roof slope
   • Direction from angle of bottom edge
5. Select Confirm.