Set Wall 1st Stud

Framer

Set the wall-specific first stud as follows:

  1. Do either of the following:
    • Select Panel | Framing | Framing Gallery 1st Stud when using model-based wall panels.
    • Select Classic Wall Framing | Wall Panelizing | Special Framing Set Wall 1st Stud when using wall panels based on a panel drawing.
  2. Click the starting point of the studding. The macro needs to be placed on top of the framing, but not necessarily at the center of the framing. The studs will be distributed from the starting point to both directions according to the stud spacing.