Move the Break Point of a Panel

Framer

Move a break point created when generating panel breaks as follows:

  1. Select Modeling | Panel | Wall Move Panel Break.
  2. Select the break point (A).
  3. Select the new location (B).
  4. Quit by pressing the Esc key.

You can also move the break point from the grip point:

  • Move the end grip point of a wall panel in the floor plan drawing.

  • Move the edge grip point of a wall panel in the framing model.

Note:
  • If you have defined a break point using a panel macro, you can relocate the macro by dragging the grip point before generating the panel breaks. After generating the panel breaks, the macro and the break point are no longer connected.